Brother MFC-J4440DW Online User's Manual page 449

Error Message
Jam Inside/Front
Repeat Jam
Jam Rear
Low Temperature
No Caller ID
No Device
Cause
The paper is jammed in the machine.
More than one sheet of paper was placed
in the manual feed slot.
-OR-
Another sheet of paper was placed in the
manual feed slot before the LCD
displayed Insert one sheet at a
time..
The paper is jammed in the machine.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The room temperature is too low.
There is no incoming call history. You did
not receive calls or you have not
subscribed to the Caller ID service from
your telephone company.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
Action
Make sure the paper guides are set to the
correct paper size.
DO NOT extend the paper tray when you
load A5 or smaller size paper.
Gently remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Front of the
Machine (Jam Inside/Front).
Make sure the paper guides are set to the
correct paper size.
DO NOT extend the paper tray when you
load A5 or smaller size paper.
Do not put more than one sheet of paper
in the manual feed slot at any one time.
Wait until the LCD displays Insert one
sheet at a time. before you feed the
next sheet of paper in the manual feed
slot.
Gently remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Front of the
Machine (Jam Inside/Front).
Gently remove the jammed paper.
See Related Information: Paper is
Jammed in the Back of the Machine (Jam
Rear / Jam Tray2).
Make sure the paper guides are set to the
correct paper size.
DO NOT extend the paper tray when you
load A5 or smaller size paper.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers for Paper Tray #1.
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
To use the Caller ID feature, contact your
telephone company.
See Related Information: Caller ID.
• Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are manually configuring the Wi-
Fi Direct network, make sure you have
entered the correct password.
• If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
442