Energizer EZ40VTDE46N Manual page 9

UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
a. To raise handle assembly:
• Pull up and back on the lower handle (1) until it is aligned with the hole
position of the arm support and the mower housing.
• To secure the lower handle (1) in place, lock the lower screw (3).
• Open the upper cam locks (2).
• Pull up and back on the upper handle to raise it into operating position.
• To secure the upper handle in place, close the upper cam locks (2).
NOTE: If the upper handle is loose or separated from the lower
handle, tighten the knobs on the upper handle locks by turning them clockwise.
INSTALLING THE GRASS CATCHER BAG
• Lift the rear discharge door (1).
• Lift the grass cat her by its handle (2) and place under the rear
discharge door so that the hooks (3) on the grass catcher are seated
on the door rod (4).
• Release the rear discharge door. When installed correctly, the
hooks on the grass catcher will extend through the openings on the
rear discharge door.
NOTE: When using the grass catcher, do not install either the
side discharge deflector or the mulching plug.
INSTALLING/REMOVING THE MULCHING PLUG
• To remove the mulching plug, lift the rear discharge door
(1).
• Grasp the handle (2) of the mulching plug.
Lift and pull the mulching plug out using the handle.
• The mulching plug (3) is inserted at an angle, so it requires
some force to remove it.
• The mulching plug must be removed in order to install the
grass catcher bag.