Energizer EZ40VTDE46N Manual page 16

Cordless lawnmower
Table of Contents

Advertisement

Always remove battery when servicing or transporting the mower.
PROBLEM
The mower does -not
start.
The mower cuts the grass
unevenly.
The mower does not
mulch properly.
The mower is hard to
push.
The mower is excessively
noisy and vibrates.
POSSIBLE CAUSE
The battery is not charged.
The switch is defective.
Grass jammed between the deck and blade.
The battery is not fully inserted in the mower.
Battery may require service or replacement.
The lawn is rough or uneven.
The cutting height is not set properly.
Wet grass clippings are sticking to the
underside of the deck.
The mulching plug is missing.
The grass is too tall, or the cutting height is
too low.
The rear of the grass catcher bag is dragging
in thick grass.
The motor shaft is bent.
The blade is unbalanced.
SOLUTION
Charge the battery.
Replace the switch
Remove battery; check under deck
for jams.
Check the connection between the
battery and the mower. Make sure
the battery clicks into place.
Replace battery.
Check the mowing area.
Move the wheels to a higher
setting.
Wait until the grass dries before
mowing.
Install the mulching plug.
Raise the cutting height.
Empty the grass clippings from the
grass catcher bag.
Stop the motor, and inspect for
damage.
Repair before restarting.

Advertisement

Table of Contents
loading

Table of Contents