Sharp LS013B7DH01 Manual page 7

【Operation Precautions】
(1) Do not use polychloroprene (CR) with LCD module. It will generate chlorine gas, which will damage the
reliability of the connection part on LCD panel.
(2) Be sure to use LCD module within the recommended operating conditions. Operating module out of the
recommended range is not guaranteed even if it is in the absolute maximum rating.
(3) When handling LCD modules and assembling them into cabinets, please avoid long-term storage in the
environment of oxidization or deoxidization gas. The use of materials such as reagent, solvent, adhesive, resin,
etc. which generate these gasses, may cause corrosion and discoloration of the modules. Do not use the LCD
module under such environment.
(3) To prevent reduction in optical quality and abnormal display, avoid exposure and contamination of the LCD
panel from epoxy resin (amine system curing agent) that comes out from the material
and the packaging material used for the set side, the silicon adhesive (dealcoholization system
and oxime system), and the tray blowing agents ( azo-compound), etc.
Please confirm LCD panel compatibility with materials employed in your manufacturing and shipping processes.
(4) If stored at the temperatures lower than the rated storage temperature, the LC may freeze and it may cause
LCD panel damage. And If stored at the temperatures higher than the rated storage temperature, the LC will
lose its characteristics, and it cannot recover. Please keep it at near room temperature.
(5) Do not operate the LCD panel under outside of electrical specification. Otherwise LCD panel may be damaged.
(6) Do not use the LCD panel under outside of specified driving timing chart. Otherwise LCD panel may not have
proper picture quality.
(7) A still image should be displayed less than two hours, if it is necessary to display still image longer than two hour,
display image data must be refreshed in order to avoid sticking image on LCD panel.
(8) If LCD module takes a static electricity, as the display image which is written into pixel memory might not be
displayed, Data update should be executed frequently.
(9) It is neither a breakdown nor a defective indication though very slight change in black level might be periodically
seen in a black part on the black display image according to the source of light (angle of the luminance and the
source of light).
(10) Be sure to follow the absolute maximum rating in the specification. The design should consider the surrounding
temperature, the fluctuating input signal, and tolerance of the electronic parts. Exceeding values is possible to
cause worse characteristic such as burn and/or broken of the parts on LCD module.
(11) Follow the power, signal, and supply voltage sequence which the specification indicates, regarding on-off input
signal after power on of LCD module.
(12) According to the using application, power circuit protection is recommended at module failure.
(13) Nature of dew consideration prevention is necessary when LCD is used for long time under high-temperature
and high-humidity
©Copyright 2017 SHARP All rights reserved
SPEC No. MODEL No.
LD-29608A
LS013B7DH01
PAGE
5