BMW X5 2023 Owner's Manual page 260

CONTROLS
▷ Ultrasonic sensors in the front/rear bump-
ers.
▷ Ultrasonic sensors, side.
▷ Front camera.
▷ Top view cameras.
▷ Rearview camera.
Recording maneuver
General information
Up to ten maneuvers can be recorded at differ-
ent locations.
Up to four overlapping maneuvers can be re-
corded.
Identical maneuvers under different ambient
conditions can be recorded, such as light con-
ditions.
For each maneuver, a maximum distance cov-
ered of 656 ft/200 m is possible.
In total, a distance covered of approx.
1,969 ft/600 m distributed to the ten possible
maneuvers can be recorded.
Maneuvers with a distance covered of less
than 20 ft/6 m cannot be recorded.
Recording maneuver
1. Drive the vehicle to the starting point from
which a maneuver must be recorded and
stop.
2. Press the button.
The parking assistance systems view is
displayed.
3. "Record new path"
4. Drive the vehicle to the desired end posi-
tion.
The maneuver is recorded.
When recording a route, do not drive faster
than 9 mph/15 km/h.
While recording, the distance covered will
be displayed.
260
Parking
Online Edition for Part no. 01405A7D5F9 - II/23
When the maximum distance covered or
the maximum speed is reached, a message
will be displayed and a signal tone will
sound.
5. With a stationary vehicle: "Save recording"
6. "Name:"
If necessary, enter the desired name for the
recorded maneuver.
7. "Save recording"
Do not move the vehicle until the recording
has been stored.
Performing stored maneuver
1. Drive the vehicle into the activation range
and stop. The control display and instru-
ment cluster indicate that a stored maneu-
ver can be activated.
2. : activate stored maneuver.
Green: after activation, the system takes
control of the vehicle and performs the ma-
neuver automatically. If applicable, follow
the instructions on the control display or in
the instrument cluster.
The speed can be reduced with the brake.
Other interventions will cancel the system.
At the end of the parking operation, selec-
tor lever position P is set.
Canceling the Maneuver Assistant
manually
The vehicle can be controlled manually during
an active maneuver by taking the following ac-
tions:
▷ Step lightly on the accelerator pedal twice
in succession.
▷ Step lightly on the accelerator pedal and
move the steering wheel slightly at the
same time.
▷ Step on the brake pedal and operate the
selector lever at the same time.