Suptek SPM201 Installation Manual

Suptek SPM201 Installation Manual

Advertisement

Quick Links

INSTALLATION MANUAL

UNPACKING INSTRUCTIONS

·Carefully open the carton, remove contents and lay out on cardboard or
other protective surface to avoid damage.
·Check package contents against the supplied parts list in the next page
to assure that all components wete received undamaged. Do not use
damaged or defective parts.
·Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

·
Install and operate this device with care. Please read this instruction
before installation, and carefully follow all instructions contained herein.
Use proper safety equipment during installation.
·Please call a qualified installation contractor for help if you don't
understand these directions or have any doubts about the safety of the
installation.
Do not use this product for any purpose or in any configuration not
explicitly specified in this instruction. We hereby disclaims any and all
liability for injury or damage arising from incorrect assembly, incorrect
mounting, or incorrect use of this product.

Before you start

Supplied parts list

SPM201
WARNING
Step 1
·3.8MM drill bit

Tools Required

·Phillips Screwdriver ·carpenter's level
CAUTION!
This monitor desktop mount must be securely
attached to the horizontal desk. If the mount isnot
properly installed it may fall, resulting in possible
injury and/or damage.

Mounting the wall bracket to the wall

·8MM masonry bit

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPM201 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Suptek SPM201

  • Page 1 Supplied parts list SPM201 INSTALLATION MANUAL UNPACKING INSTRUCTIONS ·Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage. ·Check package contents against the supplied parts list in the next page ·3.8MM drill bit ·8MM masonry bit...
  • Page 2 Attaching the wall bracket cover and the Placing speaker on the platform,adjust Step 2 Step 3 speaker platform to wall bracket clamps to hold speaker in place OPTIONAL:secure speaker using Adjusting the tilting angle and swing Step 4 Step 5 M4x12 wood screws the speaker Thank you for choosing our products!

Table of Contents