Zehnder Rittling ComfoSpot 50 Manual page 19

4. Undo and remove the two screws for fastening the control panel carrier, bring them onto the opposite side, and fasten
the control panel carrier equally on the two screw-in mandrels.
5. Guide the ribbon cable through the frame opening of the bottom cover and the control panel carrier. Restore the plug
connection between the ribbon cable and control panel.
6. Install the ribbon cable in the designated fixing points, taking care to produce a smooth overlapping in the vicinity of the
90° bends. Then snap the control panel onto the control panel carrier in the correct position.
NOTE
Pull the plug of the ribbon cable cautiously out of the post connection.
NOTE
Watch out for the reverse polarity protection for the post connection
when connecting.
NOTE
When positioning the top cover, make sure that the cut-out on the
curved surface of the top cover is on the side of the control panel.
17