Advertisement
Figure 13
1. PTO lever
2. PTO cable
3. Clamp
4.
Secure the PTO cable to the PTO lever support
with a clamp and 2 self tapping screws
13).
5.
Insert other end of the PTO lever cable through
the opening in right side of the console and
through the cable holder in the rear of the
console
(Figure
14).
Note:
Route the cable, along the existing
cables to the cable bracket mounted at front left
corner of the transaxle.
Figure 14
1. PTO Cable
2. Cable bracket
6.
Loosen the rear jam nuts on cable and insert
the end of cable into the opening in the bracket.
Loosely secure the PTO cable to the bracket
with the jam nuts.
7.
Using the 3 self tapping screws supplied in the
kit, mount the PTO lever support to the right side
of console.
Note:
The lever location is shown in figure 8.
g028752
4. PTO lever support
5. Self-tapping screws
(Figure
g028750
3. Jam nut
8.
Clean console plate and install the operation
decal to the console next to PTO lever, locating
the decal as shown in
1. Console
9.
Install the console cover plate and the lever
knobs to machine.
Note:
When the PTO is engaged, the lever
must not contact the center console plate.
4
Installing the PTO to the
Transaxle
No Parts Required
Removing the Transaxle Cover
Plate
Note:
The remaining steps pertain to installing
the kit on all vehicles unless otherwise specified.
1.
Disconnect the hydraulic hose from the fitting on
transaxle cover
Note:
Cap end of hose to prevent contaminants
from entering hose.
6
Figure
15.
Figure 15
2. Operation decal
plate(Figure
16).
g028754
Advertisement
