Advertisement
Installation
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
For machine models with a utility bed, perform
the following:
A.
Raise the bed until the lift cylinders are fully
extended; refer to the Operator's Manual
for the machine.
B.
Remove the bed support from the storage
brackets on back of the ROPS panel
1).
1. Bed Support
C.
Push the bed support onto the cylinder
rod, making sure the support end tabs rest
on the end of cylinder barrel and on the
cylinder rod end
Figure 1
(Figure
2).
1. Bed support
2. Cylinder barrel
3.
Engage the parking brake.
(Figure
4.
Shut off the engine and remove the key.
5.
Disconnect the battery as follows:
A.
Squeeze the battery cover to release the
tabs from battery base
g002397
B.
Remove the battery cover from the battery
base
C.
Remove the terminal of the positive battery
cable from the battery post
Note:
battery cable does not touch the battery
post.
2
Figure 2
3. Bed
(Figure
Figure 3
(Figure
3).
(Figure
Ensure that the terminal positive
g009164
3).
g010326
4).
Advertisement
