The Cd 6C Ex Sensor - Siemens LDS 6 Operating Instructions Manual

4.4

The CD 6C Ex sensor

Each measurement channel is available in this ATEX version for measurements in explosive
areas. The CD 6C Ex sensor is used for measurements in these kind of measurements. In
this ATEX version the CD 6C Ex sensor is used. For this set-up a barrier box needs to be
installed between the central unit and the sensor pair. This barrier box needs to be installed
in a safe environment (just as the central unit), fairly close to the central unit. The figure
below shows the ATEX set-up.
Figure 4-3
See also
ATEX considerations (Page 24)
Sensor CD 6C Operating Instructions
Operating Instructions, 12/2007, A5E00912721-02
The ATEX sensor setup
Technical Description
4.4 The CD 6C Ex sensor
29