Table of Contents
Advertisement
Problem and alarm code
The appliance does not fill with water.
•
The end indicator flashes 1 time intermittent‐
ly.
•
The
indicator flashes continuously.
The appliance does not drain the water.
•
The end indicator flashes 2 times intermit‐
tently.
•
The
indicator flashes continuously.
The anti-flood device is on.
•
The end indicator flashes 3 times intermit‐
tently.
•
The
indicator flashes continuously.
The appliance stops and starts more times dur‐
ing operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
Rattling/knocking sounds from inside the appli‐
ance.
The appliance trips the circuit-breaker.
Refer to "Before first use", "Daily use",
or "Hints and tips" for other possible
causes.
Possible cause and solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap and contact an Authorised Service
Centre.
•
It is normal. It provides optimal cleaning results and energy
savings.
•
If the delayed start option is set, cancel the delay setting or
wait for the end of the countdown.
•
The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and the
capacity of the meter or turn off one of the appliances in
use.
•
Internal electrical fault of the appliance. Contact an Author‐
ised Service Centre.
Once you have checked the appliance, press
. If the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
ENGLISH
19
Advertisement
Table of Contents
