Table of Contents
Advertisement
MAINTENANCE
Before cleaning, inspecting, or servicing
the product, turn it off, allow the cutters to
completely stop, and remove the battery
pack. After some time of shredding, the
cutting mechanism will become hot. Allow
it to adequately cool down before cleaning,
inspecting, or adjusting.
WARNING! The cutter blades are extremely
sharp. To avoid injury, exercise extreme
caution and care when cleaning or working
near the blades or inside the opened enclosure
when the collection bin is removed. Always
wear heavy-duty protective gloves.
■
Be aware that the cutting means can still be
moved even when the power is off or if the
interlock switch is engaged.
■
To ensure the best performance from the
product, it must be kept clean.
■
Always clean the product immediately after
use. Wherever possible, use a stiff brush
inside the feed and discharge chutes and a
dry cloth on the outside of the product.
■
Do not allow material to become dry and
hard on any of the product surfaces,
particularly on the blades. This directly
affects the shredding performance.
■
Make sure that the feed chute and the
ejection chute are kept clean and clear of
all waste material.
■
Make sure that all nuts, bolts, and screws
(except the adjusting screw) are tight and
secure.
■
Always have any damaged or worn parts
repaired, or replaced by qualified personnel
at an authorised service centre.
■
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils,
etc., come in contact with plastic parts.
Never use brake fluids, gasoline, petroleum-
based products, or any solvents to clean
the product. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
■
You may perform maintenance tasks
described in this manual. For other repairs,
have the product serviced by an authorised
service centre only.
OVERLOAD PROTECTION DEVICE
The product has an overload protection
device. When overloading is detected, the
overload light will turn green, and the product
will automatically turn off. Remove the battery
pack and follow the instructions for clearing a
blockage. Let the motor cool down for 3 to 5
minutes. After checking if there is no blockage,
install the battery pack. Press the start button
to turn on the motor.
If the overload protection is activated and there
is no blockage, the overload may have occurred
when materials are fed into the product too
quickly for too long, causing the motor to
overheat. Allow the motor to cool down. Empty
the collection bin before restarting the product.
SYMBOLS ON THE PRODUCT
Read and understand
all instructions before
operating the product. Follow
all warnings and safety
instructions.
Beware of thrown or flying
objects. Keep all bystanders,
especially children and pets,
at least 15 m away from the
operating area.
Warning! Disconnect
the battery pack before
maintenance, adjusting, and
cleaning.
Danger! Rotating blades. Keep
hands and feet out of openings
while the product is running.
Wear eye and ear protection.
Wear non-slip, heavy-duty,
protective gloves when
handling the product.
5
Original Instructions
Advertisement
Table of Contents
