Advertisement
What's In The Box
Please inspect the contents of your shipped package to ensure you have received everything that is listed
below.
Mounting Plate
(Top Mount & Bottom Mount)
No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright
Electro Magnet Quick Release Mitchel
Mount
A s s e m b l y M a n u a l
Wrench
All rights reserved.
statutes or in writing by the Publisher.
(QR-ELMG-01 )
D-Type Cable
Battery Plate with
Clamp (Front Side
1
& Back Side)
Advertisement
Table of Contents
Related Manuals for PROAIM QR-ELMG-01
Summary of Contents for PROAIM QR-ELMG-01
- Page 1 Electro Magnet Quick Release Mitchel Mount (QR-ELMG-01 ) A s s e m b l y M a n u a l What’s In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below.
- Page 2 Hard Case Electro Magnet Setup • Loosen castle nut from the top mount. • Now attach it to the airwave (Not Included). • Secure it by tightening the castle nut. • Remove the bottom mounting plate by pulling the button off the mounting plate.
- Page 3 • Unlock the connector holder (Not Included) and press the button on the gimbal connector (Not Included). • After unlocking, gimbal connector (Not Included) connector holder (Not Included) will look like this. • Mount the Gimbal connector (Not Included) on the bottom mounting plate. •...
- Page 4 • Unscrew the connector holder (Not Included) detach quick-release plate (Not Included). • Mount connector holder (Not Included) on the gimbal (Not Included). • Screw it using the Allen Key. • Now, secure the gimbal (Not Included) to the mounting plate by pushing the connection holder's buttons and closing the knob.
- Page 5 • Slide the camera (Not Included) with the plate onto the gimbal (Not Included) then close the knob. • The Gimbal (Not Included) is now attached. • Now loosen the lever lock to open the clamp of the battery plate. •...
- Page 6 • Turn on the switch on the side of the battery plate. YOUR PROAIM AIRWAVE ULTRA VIBRATION ISOLATOR ARM ALL DRESSED UP AND READY TO GO! (SHOWN WITH OPTIONAL ACCESSORIES) Warranty: We offer one year warranty for our products from date of purchase. Within this period of time, we will repair it without charge for labor or parts.
Need help?
Do you have a question about the QR-ELMG-01 and is the answer not in the manual?
Questions and answers