Controls - Igo ELITE 3D hd User Manual

DISPLAY & FUNCTIONS

CONTROLS

Turning the ebike ON/OFF
Press and hold the 'POWER' Button for 2 seconds to turn the electric system on or off.
The control panel can only be used when the battery is connected to the ebike. If the
system is not used for a duration of 5 minutes, it will shut itself off to conserve battery.
Selecting the display mode
Short press the 'MODE' button to cycle through the different modes of the display.
Speed/Avg. Speed/Max. Speed/Trip Distance/ODO/Time.
Adjusting the pedal assistance levels
Use the 'PLUS' and 'MINUS' buttons to select the different levels
of pedal assistance. (0 - 9).
Power level 9 gives the strongest assistance from the motor.
In power level 0 the motor does not provide any pedal assistance or throttle
but you will still be able to use the lights and functions of the display.
NOTE: The battery will run out of power quicker when
using a higher level of pedal assistance.
Lighting
With the ebike's power on , hold the 'PLUS' button for 2 seconds to turn on the lighting
system. This will turn on the backlight for the display, as well as the front and rear
lights. Holding the 'PLUS' button for 2 seconds again will turn the lighting system off.
NOTE: The lighting system is powered through the ebikes lithium-ion battery.
Walk Assist
Hold down the 'MINUS' button to initiate walk assist mode. The bike will move
at a steady pace of 6km/h - intended to facilitate walking with the bike up
ramps or light slopes, parking etc. until the 'MINUS' button is released.
8