Table of Contents
Advertisement
ADJUSTING YOUR ELECTRIC BIKE
INSTALLING YOUR STEM
Before inserting stem onto fork tube please loosen 2 side
screws using a 4mm allen key figure 19.1
Slide the stem lock on the left side down to unlock and lift lever. Figure 19.3, 19.4
Push stem down to its lowest position and insert the 5mm allen
key into stem as show in figure 19.2 and tighten .
Push down onto the lever to its original down position until it locks back into place.
Check to make sure that handlebars are centered to front wheel
and tighten 2 stem side screws using 4mm allen key.
Fig. 19.1
Fig. 19.2
ADJUSTING STEM ANGLE & HANDLEBAR POSITION
Once installed, the stem on your Elite 3D requires no tools to adjust
creating an extremely comfortable and ergonomic riding position.
To adjust the stem slide the lock button on the left side of the stem down as
shown in figure 19.3. Lift the lever up as far as it will go as in figure 19.4.
Place both hands on the grips of the handlebar and manipulate handlebars
to your most comfortable position . You will be able to lift and lower , change
the angle, and move toward or away. Adjust to an angle that is comfortable
to you, your forearms should be in line with the brake levers.
Once you have the correct position push lever back down to its original position
. As you return stem adjustment arm to its position you will here a small click
of the lock which will insure that this position is now locked into place.
Fig. 19.3
Fig. 19.4
19
Advertisement
Table of Contents
