Care & Maintenance; Replacing Hepa/Carbon Filters - LEITZ TruSens Z-6000 Owner's Manual

CARE & MAINTENANCE
WARNING: Always power off the purifier by pressing the
Power Button and unplugging the power cord.
To access the filter chamber, gently remove both side panel
filter doors (Fig. A).

REPLACING HEPA/CARBON FILTERS

The HEPA and Carbon indicators will glow red when it is
time to change the combination filter.
1. Gently remove the washable prefilters from both sides
(Fig. B).
Refer to page 16 for cleaning instructions.
2. Remove the current combination HEPA/Carbon filters
from both sides (Fig. C).
3. Gently install the replacement combination HEPA/
Carbon filters with the HEPA layer (white) on the inside,
and the Carbon layer (black) on the outside (page 10).
4. Replace the prefilters and side panel filter doors on both
sides (page 10).
5. Plug-in and power on your purifier, and hold the Reset
button until the red filter indicators turns off.
Refer to page 14 for HEPA/Carbon filter replacement part number.
Fig. A
Fig. B
Fig. C
15