USSC USG730SS Owner’s Instruction And Operation Manual page 8

ASSEMBLY INSTRUCTIONS
3. Drip Pan
• Place the disposable pan into the drip pan holder and
slide into place.
• NOTE: Make sure that the pan is aligned with the drip
hole
4. Initial Firing System Check
IMPORTANT:
DO NOT PUT ANY PELLETS INTO THE HOPPER
OR GRILL DURING THE INITIAL FIRING SYSTEM
CHECK.
• Open the pellet hopper lid to check for foreign objects
in the hopper.
• Plug the grill into a three-wire, grounded wall outlet.
• Press the power button to turn the unit on. DO NOT
TOUCH THE AUGER OR THE IGNITOR! Open the
hopper lid and check to see that the auger is turning
freely - approximately 2 rpm. LOOK TO SEE THAT THE
AUGER IS TURNING. DO NOT TOUCH.
• Place your fingers over the burn pot and feel the air
movement from the combustion blower. Ignitor will
glow within 1 minute.
© 2021 United States Stove Company
• Press the power button to turn the unit off.
• Clean the drip pans, flame plate, warming grate, and
grill grate with soap and water, then rinse. Allow the
components to dry before continuing the assembly. DO
NOT TOUCH THE IGNITOR OR THE AUGER.
STEP 3 GRILL SURFACE, DRIP PAN, AND
FLAME PLATE ASSEMBLY
1. Flame Plate Installation
• There are two cutouts along the bottom edge of the
flame plate, one in the front and one in the rear. Use
the two cutouts to position the flame plate accurately.
NOTE: One side of the flame plate is longer than the
other. When installing the flame plate ensure that the
longer side is installed to the rear of the unit.
WARNING:
IF THE FLAME PLATE IS INSTALLED INCORRECTLY
THE PELLETS MAY BURN BACK INTO THE HOPPER,
AND/OR THE GRILL MAY SMOKE EXCESSIVELY
DURING COOK MODE AND MAY NOT MAINTAIN
SET COOKING TEMPERATURE PROPERLY.
Front Of
The Unit
2. Drip Pan Installation
8
Rear Of
The Unit