Table of Contents
Advertisement
sAFETY WARning
DEATH OR INJURY FROM
INCORRECT USE
FLAT HARD LEVEL
GROUND
REFER TO VEHICLE MANUFACTURER'S
MANUAL FOR INSTRUCTIONS
Package Contents
The package contains:
1 Service Jack
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Description (Fig. A)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Top actuating handle
1
Saddle
2
Front wheel
3
Lifting arm
4
Rear swivel casters
5
Release valve
6
Unit cover
7
Carrying handle
8
Lower actuating handle
9
USE TWO SUPPORT
STANDS
FREE TO ROLL DURING
LIFTING AND LOWERING
Intended Use
This jack is intended for lifting vehicles prior to installing jack stands.
Compact design allows for use in confined spaces. Easily fits under
low vehicles. Not intended for professional use.
COMPliEs WiTh COnsUMER gOOD
(TROllY JACKs) sAFETY sTAnDARD 2017
ASSEMBLY AND ADJUSTMENTS (FIG. B, C)
•
Prior to each use, visual inspection shall be made to the
device by checking for abnormal conditions including
cracked welds, leaks, and damaged, loose, or missing parts.
•
Consult the vehicle owner's manual to determine the
location of lift points.
•
Be sure to set the vehicle in park with the emergency brake
on and chock the unlifted wheels of the vehicle.
•
Be sure that the vehicle and the jack are on a hard,
level surface.
1. Insert the top actuating handle
handle socket
10
.
2. Insert the provided hex head bolt
handle assembly and tighten the hex lock nut
hex bolt as shown in Fig. B..
nOTE: Ensure the two handle pieces are secured together.
3. Insert the fully assembled actuating handle
handle socket
14
of jack as shown in Fig. C.
OPERATION
Lifting (Fig. C)
WARNING: Immediately after lifting, support the vehicle
with appropriately rated jack stands.
1. Using the assembled actuating handle
valve
6
clockwise to the closed position. Do not overtighten.
2. Position the jack under the specified lift point.
3. Begin lifting by pumping the assembled actuating handle
up and down.
4. Immediately after lifting, support the vehicle with
appropriately rated jack stands.
5. Turn the release valve
6
the vehicle onto jack stands.
WARNING: Immediately after lifting, support the vehicle
with appropriately rated jack stands.
Lowering (Fig. C)
WARNING: Do not get under or let anyone get under the
vehicle while lowering
1. Using the assembled actuating handle
valve
6
clockwise to the closed position. Do not over tighten.
2. Pump the assembled actuating handle up and down to lift
vehicle off jack stands.
3. Remove the jack stands. Do not get under or let anyone get
under the vehicle while lowering.
4. Turn the release valve slowly counterclockwise to lower the
vehicle onto the ground.
English
1
into the lower actuating
11
through the actuating
12
onto the
13
into the
13
, turn the release
slowly counterclockwise to lower
13
, turn the release
3
Advertisement
Table of Contents
