The menu structure is as follows:
↓
submenu
HIST
↓
1
HI1H
↓
2
HI8H
↓
3
HI12
↓
4
HI24
↓
5
HI2D
↓
6
HI7D
↓
7
HIAL
↓
8
HILA
↓
9
_RST
↓
EXIT
History menu HIST
HI1
Displays the alarm history for the last hour
HI8
Displays the alarm history for the last 8 hours
HI12
Displays the alarm history for the last 12 hours
HI24
Displays the alarm history for the last 24 hours
HI2D Displays the alarm history for the last 2 days
HI7D Displays the alarm history for the last week
HIAL
Displays the alarm history for the en�re memory (cca 34 days)
HILA
Displays the alarm history since the last reset of the entry _RST
_RST Resets the time from which „HILA" starts coun�ng
EXIT
Returns one level up in the menu
This menu displays the highest measured concentration for each channel in a selected �me interval. You can choose from a
total of 8 intervals: - the last 1h (HI1H), 8h (HI8H), 12h (HI12H), 24h (HI24), 2 days (HI2D), 7 days, the en�re memory (cca 34
days) and the interval since the last reset of „_RST". Selec�ng an entry will perform a custom search in the memory for the
selected channel. If the concentration hasn't changed and remained on the minimal value during the whole interval,
„9999" will be displayed instead of the date and time. Switch between the channels by using the arrows and use ENTER to
return to selec�ng a time interval.
The entry _RST serves for se�ng the time interval for the user alarm. If an alarm was ac�vated at one of the transmi�ers
since the last change of the entry _RST, the basic status of the controller displays the segment „H". At the entry, the date and
�me since evalua�on of „HILA" are displayed. Pressing ENTER on this entry sets the interval to the current date and time and
the segment H disappears from the basic display. Press ENTER again to return the the history menu.
Note.: In the case of equipping a larger quan�ty of transmi�ers, the loading of the history may take a few seconds.
Informa�on menu INFO
NCAL
Displays the date of the next transmitter calibra�on
LCAL
Displays the date of the calibra�on
TEMP
Displays the temperature of the DEGA Tc II sensor
EXIT
Returns one level up in the menu
→
→
INFO
←
NCAL
←
↓
LCAL
↓
TEMP
↑
↓
↓
EXIT
→
↑
→
←
→
CONF
TEST
TMP1
←
RELE
↓
↓
TMP2
TRAN
↓
↓
ALM1
_RST
↓
↓
ALM2
EXIT
↓
↑
ALM3
↓
ALM4
↓
CALI
↓
EXIT
→
10
→
SERV
←
SERV
←
↓
SERV
↑
↑
↓
EXIT
→
→
↑
→
EXIT