Table of Contents
Advertisement
Figure 15. XCC system management port LEDs
LED
Description
XCC system
Use this green LED to distinguish the network connectivity status:
1
management port
• Off: The network link is disconnected.
(1GB RJ-45)
• Green: The network link is established.
Ethernet port link
LED
XCC system
Use this green LED to distinguish the network activity status:
2
management port
• Off: The server is disconnected from a LAN.
(1 GB RJ-45)
• Green: The network is connected and active.
Ethernet port
activity LED
External Diagnostics Handset
The External Diagnostics Handset is an external device that is connected to the server with a cable, and it
allows quick access to system information such as errors, system status, firmware, network, and health
information.
Location of the External Diagnostics Handset
Location
The External Diagnostics Handset is connected to the
server with an external cable.
Note: When unplugging the External Diagnostics Handset, see the following instructions:
Callouts
External Diagnostics Handset
1
Magnetic bottom
2
With this component, the diagnostic handset can be
attached to the top or side of the rack with hands spared
for service tasks.
External Diagnostics Handset connector
3
This connector is located on the front of the server, and is
used to connect an External Diagnostics Handset.
Chapter 2
.
Server components
39
Advertisement
Table of Contents
