Table of Contents
Advertisement
Figure 11. Front operator panel LEDs
Table 13. Front operator panel LEDs
"Power button with power status LED (green)" on page
1
33
"Network activity LED (green)" on page 33
2
1
Power button with power status LED (green)
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The states of the power LED are as follows:
Status
Off
Flashing rapidly (four
times per second)
Flashing slowly (once
per second)
Lit
2
Network activity LED (green)
The network activity LED helps you identify the network connectivity and activity.
Color
Description
None
No power supply is properly installed, or the LED itself has failed.
Green
The server is turned off and is not ready to be turned on. The power button is
disabled. This will last approximately 5 to 10 seconds.
Green
The server is turned off and is ready to be turned on. You can press the power
button to turn on the server.
Green
The server is turned on.
"System ID button with system ID LED (blue)" on page
3
34
"System Error LED (yellow)" on page 34
4
Chapter 2
.
Server components
33
Advertisement
Table of Contents
