Samsung AM072BXV Series Service Manual page 38

Disassembly and Reassembly
3-2 Disassembly and Reassembly (cont.)
3-2-3 Disconnecting the Power Supply (cont.)
No.
The Control Box cover does not fall off the device even
3
when the screws are unfastened, due to the supportive
tab at the top.
As shown in the image, pull the upper part of the cover
while holding the lower part and remove the cover from
the supportive tab.
Then pull down the cover to remove it.
Remove the (transparent) cover on the terminal block.
Disconnect the power cables on the input side of
the terminal block.
The power cables are fixed with screws on the terminal
block. Use a spanner or hex wrench to disconnect the
power cables. Use insulation tape to wrap each power
cable before storage to prevent the cables from coming
into contact with each other.
The front view of the device when it is ready for internal repair
after the power supply has been disconnected is shown below.
Samsung Electronics
Work Procedure Remark
2
1
Terminal
block cover
Power terminal block
on the input side
32