Xylem SonTek-SL Quick Start Manual

What's in the Case
A SonTek ‐SL
B Mounting Plate
C Cable Adaptor
D RS232 Cable
E USB Thumb Drive (SL Software)
F SL Power/Communications Cable
G AC Power Supply
H USB to Serial Adaptor
I Battery Hook‐up Cable
J Cable Conduit & Fitting (SL1500 only)
K Flow Display (Optional)
L Tool kit & Hardware (not shown)
Install SL Software
• Plug the USB thumb drive into your PC
Setup.bat
• Run and follow the instructions
• Run SL Software on your PC
• Click Software Settings (upper left corner)
o Specify a location to store data (
Units
o Select software
display, but not real time data output)
Additional Help: SL User's Manual
SL User's Manual.PDF – on the USB drive
Click the Help icon in the SL Software
Install SL Mounting Plate
• Bolt patterns for SL1500 & SL3000
• Brass hardware for corrosion resistance
1
SonTek-SL
Copyright 2014 Xylem, Inc.
Data folder
)
(this affects the software
SonTek‐SL Quick Start Guide
TM
Connect and Power the SL
USB to Serial Adaptor
• Faster and more reliable than native serial ports
• Install driver from the USB thumb drive or here:
http://www.ftdichip.com/Drivers/D2XX.htm
7‐15 VDC Power Supply
• Connect either the AC adaptor (G) or the battery
cable (I) to the cable adaptor (C)
Connect the SL to your PC
1) Connect SL cable (F) to the SL and cable adaptor (C)
2) Connect the power cable (G or I) to the cable adaptor
(C) and the power source (outlet or battery)
3) Connect RS232 cable (D) to cable adaptor (C) and the
USB to serial adaptor (H). Then connect to your PC
4) Run the SL software and click
Power
2
1
3
PC
9940 Summers Ridge Road
San Diego, CA 92121 USA
Phone +1 (858) 546‐8327
Web: www.sontek.com
Email: inquiry@sontek.com
Connect
SL
P/N 45‐0100 REV A