Electrical Interconnection - Hifonics ZEUS ZXR1200/5 User Manual

ENGLISH
FL FR RL RR

ELECTRICAL INTERCONNECTION

2CH 4CH
LINE INPUT
L R
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
SUB
a sufficient profile section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the instal-
lation, because loose connections cause malfunctions, insufficient power supply or interferences.
1
GND
1
Connect the GND terminal with a suitable contact ground point on the vehicle's chassis. The ground
wire must be as short as possible and must be connected to a blank metallic point at the vehicle's
chassis. Ensure that this ground point has a stable and safe electric connection to the negative
"–"pole of the battery. Check this ground wire from the battery to the ground point if possible and en-
force it if required. Use a ground wire with a sufficient cross section (refer to the table and the recom-
mendations on the next page) and the same size like the +12V power supply wire.
REM IN/OUT
2
Connect a turn-on signal or the turn-on remote signal of your head unit (REM) with the REM IN/OUT
terminal of the amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
the amplifier turns on or off with your head unit.
If you use the AUTO TURN-ON function (refer to page 25, section 15), the REM IN/OUT terminal
does not need to be connected. However, the REM IN/OUT terminal can then connected to the REM
terminal of another amplifier to provide a control signal to it (REM OUT function).
+12V
3
Connect the +12V terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a suf-
ficient cross section (refer to the table on the next page).
22
INPUT INPUT
X-OVER MODE
LEVEL
LEVEL FROM
FULL HP DUPE
HIGH 2CH
MIN MAX
LOW 4CH
INPUT
FROM
AUTO TURN-ON
MIN
2CH
SUB
DC VOX OFF
3
REM
GND +12V
IN/OUT
ZXR 1200/5
POWER INPUT
2
min. 80 A
FRONT
X-OVER MODE X-OVER MODE
HIGH PASS LEVEL
FULL HP LP/BP
SUBWOOFER
50 Hz 5 kHz MIN MAX
LEVEL SUB SONIC LOW PASS BASS BOOST
MAX 10 Hz 40 Hz 40 Hz 150 Hz 0 dB
6
BRIDGED
FL
POWER
PROTECT
RL
4
< 30 cm >
5
REAR
HIGH PASS LOW PASS
BP
10 Hz 500 Hz 50 Hz 5 kHz
PHASE SHIFT
BLC
REMOTE
18 dB 0° 180°
FR
SPEAKER
OUTPUT
RR
VEHICLE
BATTERY
). Hereby
2