Electrical Interconnection - Hifonics ZEUS EXTREME User Manual

ENGLISH

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are fixed tight after the installation, because loose connections
cause malfunctions, insufficient power supply or interferences.
Turn-on cable to the head
unit (car radio)
Min. Ø 50 mm
max. total length of 1.5 m
ADDITIONAL
BATTERY
Not included in the scope of delivery
+12V
1
Connect the 12 volt terminals of the amplifier to the positive poles of the power capacitors by using
suitable cables. Then connect the positive poles of the power capacitors to the 12 volt positive pole
of the additional battery.
ATTENTION: Use for both connections sufficiently dimensioned cables of at least Ø 50 mm
a total length of max. 1,5 meters. If you use longer cables, the cross-section must be correspond-
ingly larger. Use very short cable lengths from the amplifier to the power capacitors, which should be
mounted close as possible to the amplifier.
18
Min. Ø 50 mm with a
2
max. total length of 1.5 m
LINE INPUT
HIGH VOLTAGE
1.0 - 9.0 V
MIN
INPUT
SENS.
LOW VOLTAGE
0.4 - 3.6 V
1 2 3
ZXT 13000/ 1
GND
POWER INPUT
DO NOT COVER
AIR VENT
4
with a
2
< 30 cm >
5
6
SPEAKER OUTPUT
POWER CLIP
PROTECT
MAX 10 Hz 100 Hz 50 Hz 5 kHz 0 dB 12 dB 30 Hz 70 Hz
SUB LOW BASS BOOST
SONIC PASS BOOST FREQ.
4
DANGER
HIGH VOLTAGE
REM +12V +12V GND
POWER INPUT
EXTERNAL FUSE REQUIRED
DO NOT COVER
AIR VENT
Min. Ø 50 mm
2
6
max. total length of 1.5 m
Min. Ø 50 mm with a
2
max. total length of 1.5 m
with a
2
with