Electrical Interconnection - Hifonics ZEUS POWER User Manual

ENGLISH
LINE INPUT

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the instal-
lation, because loose connections cause malfunctions, insufficient power supply or interferences.
1
GND
1
Connect the GND terminal with a suitable contact ground point on the vehicle's chassis. The ground
wire must be as short as possible and must be connected to a blank metallic point at the vehicle's
chassis. Ensure that this ground point has a stable and safe electric connection to the negative
"–"pole of the battery. Check this ground wire from the battery to the ground point if possible and en-
force it if required. Use a ground wire with a sufficient cross section (refer to the table and the recom-
mendations on the next page) and the same size like the +12V power supply wire.
REM IN/OUT
2
Connect a turn-on signal or the turn-on remote signal of your head unit (REM) with the REM IN/OUT
terminal of the amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
the amplifier turns on or off with your head unit.
If you use the AUTO TURN-ON function (refer to page 25, section 15), the REM IN/OUT terminal
does not need to be connected. However, the REM IN/OUT terminal can then connected to the REM
terminal of another amplifier to provide a control signal to it (REM OUT function).
+12V
3
Connect the +12V terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a suf-
ficient cross section (refer to the table on the next page).
22
HIGH LEVEL INPUT
LINE OUTPUT
L L
LEVEL
MIN
R R
3
REM
GND +12V
IN/OUT
ZXR 1200/1
POWER INPUT
4
2
min. 100 A
AUTO TURN-ON
DC VOX OFF
ON
OFF
SUB SONIC LOW PASS BASS BOOST
MAX 10 Hz 40 Hz 40 Hz 150 Hz
SPEAKER
< 30 cm >
5
BLC
POWER
PROTECT
REMOTE
PHASE SHIFT
0 dB 18 dB 0° 180°
OUTPUT
VEHICLE
BATTERY
). Hereby
2