Electrical Interconnection; Before Connecting; Vehicle Battery - Hifonics ZEUS EXTREME ZXT1400/4 User Manual

ENGLISH

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING

For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are fixed tight after the installation, because loose connections
cause malfunctions, insufficient power supply or interferences.
ZXT 1400/4
ZXT 1400/4
VEHICLE
BATTERY
+12V
1
Connect the 12 volt terminal of the amplifier to the positive pole of the power capacitor by using a suit-
able cable (refer to the table on the next page). Then connect the positive pole of the power capacitor
to the 12 volt positive pole of the vehicle battery.
ATTENTION: Use for the connection a sufficiently dimensioned cable of at least Ø 25 mm
length of max. 2 meters. If you use a longer cable, the cross-section must be correspondingly larger.
Use a very short cable length from the amplifier to the power capacitor, which should be mounted
close as possible to the amplifier.
REM
2
Connect the turn-on signal from the head unit / car radio (REM) with the REM terminal of the power
capacitor. Then connect the REM terminal of the power capacitor with the REM terminal of the ampli-
fier. Hereby the amplifier and the power capacitor are turning on or off with the head unit / car radio.
Use therefor a suitable cable with a sufficient cross section (0,5 mm
20
FRONT
INPUT
MODE
FL RL
2CH
4CH
INPUT HIGH
SENS. PASS
FR RR
FL FR
RL RR
BRIDGED
Min. Ø 25 mm
2
max. total length of 2.0 m
< 30 cm >
REAR
X-OVER MODE X-OVER MODE
FULL HP HP FULL LP
50 Hz 500 Hz
INPUT HIGH LOW
SENS. PASS PASS
1 2 3
4
with a
5 6
Turn-on cable to the
head unit (car radio)
Min. Ø 25 mm with a
2
max. total length of 2.0 m
with a total
2
).
2