Electrical Interconnection - Hifonics ZXS900/6 User Manual

ENGLISH

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the instal-
lation, because loose connections cause malfunctions, insufficient power supply or interferences.
R+ L–
R– L+
VEHICLE BATTERY
+12V
1
Connect the +12V terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a suf-
ficient cross section (refer to the table on the next page).
GND
2
Connect the GND terminal with a suitable contact ground point on the vehicle's chassis. The ground
wire must be as short as possible and must be connected to a blank metallic point at the vehicle's
chassis. Ensure that this ground point has a stable and safe electric connection to the negative
"–"pole of the battery. Check this ground wire from the battery to the ground point if possible and en-
force it if required. Use a ground wire with a sufficient cross section (refer to the table and the recom-
mendations on the next page) and the same size like the +12V power supply wire.
22
INPUT INPUT
CH1-4 FROM CH5/6 FROM
CH1/2 CH1/2
CH1-4 CH5/6
R+ L– R+ L–
R– L+ R– L+
4
5
min. 80 A
< 30 cm >
LOW PASS
50 Hz 500 Hz
1 2
3
LP
ZXS 900/6