Electrical Interconnection - Hifonics ZXT3000/1 User Manual

ENGLISH

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are fixed tight after the installation, because loose connections
cause malfunctions, insufficient power supply or interferences.
VEHICLE
BATTERY
+12V
1
Connect the 12 volt terminal of the amplifier to the positive pole of the power capacitor by using a suit-
able cable (refer to the table on the next page). Then connect the positive pole of the power capacitor
to the 12 volt positive pole of the vehicle battery.
ATTENTION: Use for the connection a sufficiently dimensioned cable of at least Ø 35 mm
length of max. 2 meters. If you use a longer cable, the cross-section must be correspondingly larger.
Use a very short cable length from the amplifier to the power capacitor, which should be mounted
close as possible to the amplifier.
REM
2
Connect the turn-on signal from the head unit / car radio (REM) with the REM terminal of the power
capacitor. Then connect the REM terminal of the power capacitor with the REM terminal of the ampli-
fier. Hereby the amplifier and the power capacitor are turning on or off with the head unit / car radio.
Use therefor a suitable cable with a sufficient cross section (0,5 mm
18
LINE INPUT
HIGH VOLTAGE
1.0 - 9.0 V
MIN MAX 10 Hz 100 Hz 50 Hz 5 kHz
INPUT SUB
SENS. SONIC
LOW VOLTAGE
0.4 - 3.6 V
ZXT 3000/1
DO NOT COVER AIR VENT
ZXT 3000/1
Min. Ø 35 mm
2
max. total length of 2.0 m
< 30 cm >
SPEAKER OUTPUT
POWER CLIP
PROTECT
0 dB 12 dB 30 Hz 70 Hz
LOW BASS BOOST
PASS BOOST FREQ.
1 2 3
+12V REM GND
POWER INPUT
EXTERNAL FUSE REQUIRED
4
with a
5 6
DANGER
HIGH VOLTAGE
Turn-on cable to the
head unit (car radio)
Min. Ø 35 mm with a
2
max. total length of 2.0 m
with a total
2
).
2