Table of Contents
Advertisement
■14.
Power consumption
The power consumption is displayed in a graph. (It may not be displayed depending on the models.)
NOTE
• This function can only be used with corresponding indoor units and outdoor units.
This feature is not available if the equipment group connected to the remote controller includes an unsupported model, air
to air heat exchanger, or ventilation unit. The message "No function" is displayed.
• Graph data is updated every 30 minutes.
• The power consumption displayed is just an estimate as it is calculated simply. It may sometimes differ from the result
measured by the power meter.
• Do not use the values of display for considering the contracted power and calculating the power charge.
• Data is displayed at that time during the summer time period.
• When a power failure occurs, data for up to 30 minutes before the power failure will not be displayed.
• When setting data for the indoor unit is checked and/or changed, data for that period of time may not be displayed.
• When two remote controllers are connected, display function is not available with "Follower remote controller".
• Before using "Power consumption", do "Clock". (Page 46)
• If no button operation is done for 60 seconds, the display returns to the "Menu".
1
In "Menu" (Page 17), select "Power
consumption", and press [
2
Press [
] and [
graph to be displayed
The types of graphs are explained below.
3
After confirming the graph, press
[
Return]
Return to "Menu".
"Day1"
Displays today's and yesterday's data.
"Day2"
Displays data for the same day of the week today and last
week.
"Week"
Displays data for this week and last week.
– 54 –
Owner's Manual
Set/Fix]
] to select the type of
EN
Advertisement
Table of Contents
