Sub-Zero UC-15IPO Use And Care Manual page 6

O PE RAT I O N
Operation
C U B E WE I G H T
Cube weight increases or decreases depending on the
amount of dimple, or depression in the octagonal-shaped
ice cube. Cube weight can be adjusted by increasing the
freeze time.
To adjust cube weight:
Touch and hold 'POWER'.
1
Touch and release 'CLEAN' once to add one minute of
2
freeze time. Inspect the cubes after several production
cycles and repeat if a heavier cube is desired. Up to five
minutes of additional freeze time can be added.
Touch 'CLEAN' six times to reset freeze time to the
3
factory setting.
IC E L E VE L
A thermostat in the ice storage bin signals ice production to
stop when the bin is full. If ice production stops before the
bin is full or continues after the bin is full, the ice level can
be adjusted. The thermostat control is located behind the
kickplate. Refer to the illustration below.
To adjust ice level:
Remove the kickplate to access the thermostat control.
1
Turn the control to the left to decrease the level of ice or
2
to the right to increase the level.
THERMOSTAT
CONTROL
Ice level adjustment
|
6 Sub-Zero Customer Care 800.222.7820
Cleaning
IN TE RI O R C LEAN I N G
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights and control
panel.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STAI NL ESS S TEEL EX TER IO R
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.