UC-15I WATER FILTER MANIFOLD REPLACEMENT
CONTENTS
1
2
TOOLS REQUIRED
Phillips screwdriver
5
/
" Socket
16
5
/
" Combination Wrench
16
Small Flat-blade screwdriver
WARNING:
Disconnect the product from the power source before
starting this procedure.
CAUTION:
Turn off the water supply prior to performing this
procedure.
IMPORTANT: The water lines and water filter manifold may
have residual water in the components.
IMPORTANT: This service package applies to the UC-15I
between serial numbers 23014677 and 23023668.
TIP: This procedure can be performed with the unit
installed.
REMOVE THE DOOR WITH HINGES
1
Remove the hinge covers that cover the door hinge
screws from the upper and lower hinges.
2
Use a Phillips screwdriver to remove the inner
cabinet hinge screws.
3
Use a Phillips screwdriver to loosen the outer cabinet
hinge screws.
4
Push the door assembly toward the hinge side of the
unit.
5
Pull the door assembly forward over the outer
cabinet hinge screws.
6
Remove the door assembly, with the hinges
attached, from the unit.
7045211 REV A
7/2023
UC-15I Water Filter Manifold Replacement
Water Filter Manifold
Replacement Instructions
Water filter manifold
Page 1 of 3
www.subzero-wolf.com
REMOVE THE WATER FILTER
TIP: The water filter may not be installed.
1
Rotate the water filter counterclockwise until it stops.
2
Pull the water filter from the unit.
REMOVE THE KICKPLATE
5
1
Use a
/
" socket to remove the kickplate mounting
16
screws and plastic washers.
2
Remove the kickplate from the unit.
(800) 222-7820