Kobalt SGY-AIR293 Assembly Instructions Manual page 17

CARE AND MAINTENANCE
2. Screw the Air Cap Ring (A) onto the face
of the spray gun by turning it clockwise and
hand tighten.
3. Slide the Paint Needle through the back of
the Spray Gun (See Figures 3 and 4).
NOTE: Make sure the hole in the trigger is
properly aligned or the paint needle cannot be
inserted.
4. Slide Needle Spring over the Paint Needle
(See Figure 5).
5. Screw on the Fluid Adjustment Knob (E)
clockwise.
2
Clockwise
3
4
5
6
17
A
Clockwise
E