Kobalt SGY-AIR293 Assembly Instructions Manual page 16

CARE AND MAINTENANCE
8. Using wrench (J), unscrew the Fluid Nozzle
(B) by turning counterclockwise and place it
in the secondary container to soak.
9. After 3-5 minutes, remove each item and use a clean dry towel to wipe off
the entire item and inspect it for any remaining paint or dirt to wipe remains.
IMPORTANT: To ensure all residue of material is removed from the part, use
a blow gun with an approved OSHA gun tip to blow any excess cleaning
solution off the part that a rag cannot get to.
If paint or dirt debris is still present, use a non-wire soft bristle brush and
brush the area.
NOTE: Soaking of parts may require longer to get all paint residue off the
part.
RE-ASSEMBLING SPRAY GUN
1. Screw the Fluid Nozzle (B) into the face of
the spray gun by turning it clockwise, using
the wrench (J) to tighten securely.
8
1
16
B
B