Attaching The Ap Bracket To The Ap; Mounting The Ap In A Pdc - H3C WA6528X-E Installation Manual

Attaching the AP bracket to the AP

This procedure is required only for wall mounting and pole mounting.
Align the AP bracket with the screw holes on the rear of the AP, and then use M5 × 12 screws to
attach the AP bracket to the AP.
NOTE:
The AP bracket supports both horizontal and vertical installations.
• To mount the AP on a vertical pole, make sure the vertical pole mounting arrow on the AP
bracket points up. To mount the AP on a horizontal pole, make sure the horizontal pole
mounting arrow on the AP bracket points up.
• To mount the AP on a wall, you can orient the AP bracket horizontally or vertically as required.
Figure2-2 Attaching the AP bracket to the AP

Mounting the AP in a PDC

You can mount the AP in a power distribution cabinet (PDC) by using the mounting holes in the AP
rear or at AP sides.
To use the mounting holes at AP sides, attach the AP bracket as shown in
To use the four mounting holes in the rear, prepare a mounting bracket and M8 × 10 screws
yourself.
2-3
Figure2-3 to the AP.