ELNA eXtend covermax Instruction Manual page 16

z
e
x
r
c v
t
q
w
y
u
Thread the looper in the following steps:
z Draw the thread through the right side thread guide
from back to front as shown.
q Thread guide bar
NOTE:
If the thread slips out from the thread guide notch,
pass the thread through the thread guide hole again
as shown.
w Notch
e Hole
x Slide the thread into the thread guide plate on the
machine as shown.
r Thread guide plate
c Draw the thread along the slit and pass it through the
tension dial.
t Tension dial
y Tension disks
NOTE:
Hold the thread at both ends and tug gently to ensure
the thread is correctly inserted between the tension
disks.
v Draw the thread down into looper thread guide (A).
u Looper thread guide (A)
NOTE:
Pull the thread to pass it through looper thread guide
(A) until it locks in place while holding the thread at
the thread guide plate.
14