Status Read Command - Sanyo PDG-DET100L Owner's Manual

Status Read Command

Format
The command is sent from PC to the projector with
the format below;
'CR' [Command] 'CR'
Command: one character (refer to the command
table below.
The projector decodes the command and returns the
'Character string' with the format below;
Command Function
CR0 Status Read
CR6 Temperature Read
The tables on pages 88 and 89 show the typical command lists for controlling the projector. Please consult your
local dealer for further information of other commands.
Projector
Return
Power On
00
Stand-by mode
80
Countdown
40
Cooling down
20
Power Malfunction
10
Cooling down at the temperature anomaly
28
Unable to receive the RC232C command.
02
Cooling down at Power Management mode
24
Power Management mode after Cooling down
04
Cooling down after the projector is turned off when the lamps
21
are out.
Stand-by mode after Cooling down when the lamps are out.
81
Stand-by mode after Cooling down at the temperature
88
anomaly.
Cooling down when the projector is turned off by the shutter
2C
management function.
Stand-by mode after Cooling down by the shutter
8C
management function.
S1 = Temperature at Sensor 1 (˚C)
S2 = Temperature at Sensor 2 (˚C)
S3 = Temperature at Sensor 3 (˚C)
(ex.) S1 = 12.3˚C, S2 = 23.4˚C, S3 = 34.5˚C
S1 S2 S3
--> The projector displays "12.3 23.4 34.5"
( For each sensor, two digit and the tenth place numbers are
displayed with a space between each temperature.)
Communication failure
?
Projector status
Appendix
89