Sanyo PDG-DET100L Owner's Manual page 59

Enter a PIN code
Use the Point ed buttons on the side control or on
the remote control to enter a number. Press the Point
8 button to fix the number and move the red frame
pointer to the next box. The number changes to "✳. "
Repeat this step to complete entering a four-digit
number. After entering the four-digit number, move
the pointer to "Set. " Press the SELECT button so that
you can change the PIN code lock setting .
If you fixed an incorrect number, use the Point
button to move the pointer to the number you want
to correct, and then enter the correct number.
If you entered an incorrect PIN code, "PIN code" and
the number (✳✳✳✳) will turn red for a moment. Enter
the correct PIN code all over again.
Change the PIN Code Lock setting
Use the Point 7 8 button to select Off, On1, or On2 and then
move the pointer to "Quit" with the Point d button. Press the
SELECT button to close the dialog box.
Change the PIN Code
The PIN code can be changed to your desired four-digit
number. Press the Point d buttons to select "PIN code
change" and press the SELECT button. The New PIN code
input dialog box appears. Set a new PIN code.
CAUTION:
wHEN yOU HAVE CHANGED THE PIN CODE, wRITE
DOwN A NEw PIN CODE IN COLUMN OF THE PIN CODE
NO . MEMO ON PAGE 86, AND KEEP IT SECURELy . IF
yOU FORGET yOUR PIN CODE, THE PROjECTOR CAN NO
LONGER BE STARTED .
Projector ID
This feature allows users to set serial communication
configuration (Projector ID) when several projectors are
connected via the RS-232C terminal (serial port) of the
projector.
Use the Point buttons to adjust the Projector ID.
7 8
Projector ID ... 1 - 999. (Factory default setting : Projector ID
l
Enter a PIN code
7
Change the PIN code lock setting
Change the PIN code
1)
Setting
After a correct Logo PIN code is
entered, the following dialog box
appears.
Use the Point 7 8
buttons to switch
between the options.
59