Sanyo PDG-DET100L Owner's Manual page 57

Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with "No signal"
appears. It starts the countdown until the lamp is turned off. The
countdown time can be set between 1 and 30 minutes.
Use the Point 7 8 buttons to set the countdown timer.
Select one of the following options:
Ready . . . . When the lamp has been fully cooled down,
the POWER indicator starts blinking. In this
condition, the projection lamp is turned on if the
input signal is reconnected or any button on the
side control or remote control is pressed .
Shutdown . . When the lamp has been fully cooled down, the
power is turned off.
Off . . . . . . . Power Management function is off.
On start
When this function is set to "On, " the projector will be
automatically turned on just by connecting the AC power cord to
the wall outlet.
✔
Note:
• Make sure that the MAIN ON / OFF switch is ON, otherwise the
On start function does not work.
• Be sure to turn off the projector properly (see "Turning Off the
Projector" on page 25). If the projector is turned off in the incorrect
sequence, the On start function does not work properly.
Power management
Time left before the lamp is off
Press the SELECT button at Power
management and the dialog box
appears. Use the Point 7 8 buttons
to choose one of the three options.
Press the Point d button to select
the timer, and then use the Point 7
8 buttons to set the timer.
✔ Note:
•Factory default is "Ready: 5 min. "
•When the shutter is closed while the Power
management function is working, the Power
management function is released.
Setting
57