Table of Contents
Advertisement
■ External view and names of each part
Figure 2 shows the external view of the this product and the names of each part.
(1)
Adapter I/F connector
(2)
Header I/F connector
Trimpot for setting the threshold
(3)
voltage
Trimpot for setting the reset
(4)
voltage
(5)
Power switch
(6)
DC jack
(7)
NMIX control jumper plug
(8)
Mode control jumper plugs
(9)
POWER LED
(10) USER POWER LED
Check pin for the user power
(11)
supply
104.0 mm
(2)
The connector that connects to the adapter board.
The connector that connects to the header board.
A trimmer potentiometer that sets the threshold value voltage.
The factory default setting is +4V.
A trimmer potentiometer that sets the reset voltage.
The factory default setting is +3V.
Switches the power supply of the pseudo power-on debug adapter on or off.
The connector that connects to the AC adapter.
A jumper plug that configures whether the NMIX pin on the evaluation MCU
is connected to the user system or is fixed at "H" on the pseudo power-on
debug adapter.
Jumper plugs that configure the operating mode of the evaluation MCU.
Indicates whether the power supply of the pseudo power-on debug adapter
is on or off.
Indicates whether the user power supply is on or off.
A check pin for measuring the user power supply voltage.
Figure 2 External appearance
(1)
(4) (5)
(3)
(7)
(8)
(6)
(9)
(10)
(11)
3
Advertisement
Table of Contents
