Bradford White EF60T125 Service Manual page 33

If the water heater has an operating problem, there will be a number in the water heater display with "Service
Needed" shown below the error code number. Note the error code and the definition in the chart below. This
label appears on the control box under the water heater display. The following sections will provide instructions
for servicing each error code.
ERROR
CODE
4 LOW FLAME SENSE CURRENT
6 FLAME SENSED OUT OF NORMAL SEQUENCE (BEFORE OPENING GAS VALVE OR AFTER CLOSING GAS VALVE)
23 FLAME DETECTED BEFORE IGNITION
24 FLAME DETECTED AFTER A HEATING CYCLE COMPLETES
29 PRESSURE SWITCH FAILED TO CLOSE OR OPEN (STUCK OPEN)
32 LOWER SENSOR READINGS FAULTY
57 FLAME ROD SHORTED TO GROUND
58 AC LINE FREQUENCY ERROR - SIGNAL TOO NOISY OR FREQUENCY INCORRECT
59 LINE VOLTAGE TOO LOW OR HIGH
61 DC OUTPUT VOLTAGE UNSTABLE
62 MAXIMUM NUMBER OF RETRIES DETECTED
MAXIMUM NUMBER OF IGNITION RECYCLES DETECTED
63
64 ELECTRONICS FAILURE
65 HIGH WATER TEMPERATURE (OVER 200°F)
IF ANY OF THE ABOVE CODES APPEAR ON THE CONTROL DISPLAY, CONTACT YOUR PLUMBER OR QUALIFIED SERVICE AGENT FOR SERVICE OF THE WATER HEATER.
ERROR CODE DEFINITIONS
HONEYWELL INTEGRATED CONTROL ERROR CODE
DISPLAY FOR EF MODEL SERIES
Error Code Definitions
For models with Honeywell Integrated Control
DEFINITION
33
33