Bradford White EF60T125 Service Manual page 25

Step 5: 30 Seconds after the last button press, the Water Heater Display will go back to "User Mode". It will read "Max
Setpoint" without showing a temperature value if the temperature setpoint is at the maximum setting. The Water
Heater Display can be set back to the "User Mode" immediately by pressing both the "Temperature Up" and "Select"
buttons together for 3 seconds.
Display of Water Temperature:
Step 1: In Service Mode, Press the "Select" button until "Water Temp" is displayed in the upper right section of the
water heater display. This is the reading for the sensor.
Accessing Service Mode on Control Display
For models with Honeywell Integrated Control
Max
Setpoint
idle
Status Operational
SELECT SET
Exiting Service Mode
°F
idle
Operational
Status
Lower Sensor
SELECT SET
25
25