Service Menus; How To Enter The Service Mode; Changing Tvm Data Settings; Writing Tvm Data - Sony KDL-40X4500 Service Manual

3-1. How to enter Service Mode
Service adjustments to this model can be performed using the
supplied remote Commander RM-ED012.
1. Turn on the power to the TV set and enter into the stand-by
mode.
2. Press the following sequence of buttons on the Remote
Commander.
i+ 5
(ON SCREEN (DIGIT 5)
DISPLAY)
3. The TVM Service Menu appears on the screen (See Pic.1).
Pic.1
Note :
• After carrying out the service adjustments, to prevent the
customer accessing the 'Service Menu' switch the TV set OFF
and then ON.

3-2. Changing TVM Data Settings

1. Press "2 / 5" on the remote commander to select (up / down)
category (See Pic.2).
2. Press "1 / 4" on the remote commander to select (up / down)
item (See Pic.2).
3. Press "3 / 6" on the remote commander to select (up / down)
data (See Pic.2).
Pic.2
Data

3-3. Writing TVM Data

1. Press "Mute" on the remote commander. The word "SERVICE"
changes to "WRITE" (See Pic.3).
2. Press "0" on the remote commander.
3. After approximately 1 minute, "WRITE" changes to
"SERVICE". This indicates writing is complete.
Pic.3
SECTION 3
+ I/
TV
(VOLUME +) (TV)
Category
Item

SERVICE MENUS

3-4. Entering BEM Service Menu

1. Press "Previous channel
BEM menu appears (See Pic.4)
Pic.4

3-5. Changing BEM Data Settings

1. Press "2 / 5" on the remote commander to select (up / down)
category (See Pic.5).
2. Press "1 / 4" on the remote commander to select (up / down)
item (See Pic.5).
3. Press "3 / 6" on the remote commander to select (up / down)
data (See Pic.5).
Pic.5
Category
Item

3-6. Writing BEM Data

1. Press "Mute" on the remote commander. The word "SERVICE"
in green changes to "WRITE" (See Pic.6).
2. Press "0" on the remote commander. The word "WRITE" in
green changes to red. This indicates writing is in progress
(See Pic.6).
3. When "WRITE" changes to green "SERVICE". This indicates
writing is complete.
Pic.6
- 13 -
" on the remote commander and the
Data