Service Position - Sony KLV-V26A10E Service Manual

2-10.SERVICE POSITION

1. Lay TV set flat and remove the rear cover (See 2-1.). Ensure screen is shielded from damage by laying on protective material.
2. Disassemble the foot from the TV set by removing the four screws circled.
3. Remove the main brackets (See 2-2.)
4. Disconnect the harnesses connected to boards beneath the main shield case (NP1, BL and N boards). Remove the main shield case.
5. Remove the NP1, BL and N boards (See 2-8.)
6. Remove the A1board (KLV-V26A10E/KDL-V26A12U) or the A2 board (KLV-V32A10E/KDL-V32A12U) (See 2-4.)
7. Re-fit the foot to the TV set and place the set back in a vertical position. Place a support of approx 35cm high as close as possible
to the TV set as shown below.
8. Arrange the removed circuit boards as shown in the picture. Reconnect the interconnecting harnesses to the circuit boards.
Note: Two new cables are needed to connect the boards in the service position
Cable 1: Part Number: 9-948-020-73
Cable 2: Part Number: 9-948-020-72
All manuals and user guides at all-guides.com
Screws
G2 board CN6200, CN6203 to NP1 board CN5801, CN5802
N board CN3402 to A1/A2 board CN5105
– 21 –
RM-EA001/RM-ED001
35cm
AT2X