NOTE: Unless otherwise noted, screen captures in this User Guide are from the 5054-R. About This Book Before installing and using the unit, Proxim recommends you review the following chapters of this manual: • Chapter 1 “Introduction” (this chapter): Provides an overview of the content of this manual as well as wireless network topologies and combinations that can be built with the unit.
Page 11
Introduction QB.11-R Installation and Management About This Book • Chapter 4 “Basic Management”: Explains how to navigate the user interface, and discusses the most common settings used to manage the unit. • Chapter 5 “System Status”: Depicts the Web Interface’s “Status” options, including System Status and Event Logs. •...
Page 12
Introduction QB.11-R Installation and Management Reference Manual Reference Manual As a companion to the Installation and Management manual, the Tsunami MP.11/QB.11 Reference Manual provides the following supplemental information: • Command Line Interface: Documents the text-based configuration utility’s keyboard commands and parameters. •...
Introduction QB.11-R Installation and Management Wireless Network Topology (Point-to-Point Link) Wireless Network Topology (Point-to-Point Link) It is easy to set up a wireless point-to-point link as depicted in the following figure. Each unit is set up as either a Base Station Unit (BSU) or a Subscriber Unit (SU).
Page 14
Proxim provides these MIB files on the CD included with your unit. You must compile one or more of these MIB files into your SNMP program’s database before you can manage your unit using SNMP. See the documentation that came with your SNMP manager for instructions about how to compile MIBs.
QB.11-R Installation and Management Installation and Initialization This chapter describes the steps required to install and mount the QuickBridge.11 units, and to align the antenna. If you are already familiar with this type of product, you can use the Quick Install Guide for streamlined installation procedures.
Installation and Initialization QB.11-R Installation and Management Hardware Overview Hardware Overview The units contain a state-of-the-art wireless radio, a high-gain performance flat-panel antenna, and Power-over-Ethernet (the sole means of power for the unit).The unit also has built-in surge protection on its Ethernet port. Power-over-Ethernet The unit is equipped with an Power-over- Ethernet (PoE) module.
Page 17
Installation and Initialization QB.11-R Installation and Management Hardware Overview The connections are as follows: D-Shell RJ11 1 + 3 + 5...
Installation and Initialization QB.11-R Installation and Management Product Package Product Package The product’s shipping boxes should be left intact and sheltered until arrival at the installation site. Carefully unpack the QuickBridge.11 shipment and check for any shipping damage or missing parts. There are two sets of equipment in the box.
Page 19
Installation and Initialization QB.11-R Installation and Management Product Package The following mounting hardware, included with each mounting kit: Mounting Hardware (2 sets) Quantity Description 12 ea. Plain washer #5/16 4 ea. Hex Cap Screw NC 5/16-18 x 35 4 ea. Nut NC 5/16-18 8 ea.
Installation and Initialization QB.11-R Installation and Management Installation Procedure Installation Procedure IMPORTANT: Before installing and using this product, see Safety and Regulatory Compliance Information on the product CD. IMPORTANT: All units must be installed by a suitably trained professional installation technician or by a qualified installation service.
Need help?
Do you have a question about the 2454-R and is the answer not in the manual?
Questions and answers