ICP DAS USA I-7530 Quick Start Manual page 6

Hide thumbs Also See for I-7530:

After finishing the configuration, users can click the button "Save

All Setting" to save the configuration in to the I-7530. If users

would like to recover the parameters to the factory default, click

"Load Default Setting" button to recover all of the configuration

parameters to be default value. Then, users can click the button

"Save All Settings" to save the default parameters in to the

I-7530.

The default values of the parameters of the I-7530 are shown

below.

UART

Baud rate

Data Bit

Stop Bit

Parity

Add Checksum

Error Response

CAN

CAN Specification

CAN Bus Baud rate

CAN ID Filter Acceptance Code

CAN ID Filter Acceptance Mask

Communication Mode

I-7530 Communication Test

3.1 Please refer to step 2.1, set the Init / Normal switch on the back

of the I-7530 to the "Normal" position. Then, turn on the power.

The ON LED of the I-7530 will be turned on continuously. That

means that the I-7530 is boot and be in the Run mode.

115200 bps

None

2.0A

125K

000

Normal

I-7530-g