Care And Maintenance - Dirt Devil DD7004 Instruction Manual

CARE AND MAINTENANCE

Maintenance
Switch off, disconnect from the mains supply and allow steam mop
to cool fully before cleaning, maintaining or storing.
1. Remove the water reservoir stopper and empty the reservoir
after each use. Do not refit the stopper until next use.
2. Remove the microfiber cleaning pad or cloth and wash after
each use.
3. Wipe the outside of the steam mop and accessories with a
damp (not wet) cloth and then wipe dry. Do not use detergents,
solvents or abrasives as these may scratch or damage the
surface.
4. Never immerse the steam mop, cable or plug water.
5. Wind the cable onto the cable retaining hooks and note that the
upper hook can be rotated for quick release of the cable at the
time of use.
6. When not in use, store in a cool, dry place.
Replacing the microfiber pad
1. The carpet glider and one microfiber pad is supplied fitted to the
floor head.
2. To remove and replace the microfiber pad, remove the carpet
glider. Press down on the carpet glider clip, and lift the floor head
upwards (fig. 10).
Fig. 10
3. Pull off the dirty microfiber pad and place to one side for
washing.
4. Align the tapes on the underside of the clean pad with pads on
the underside of the floor head and press together (fig. 11).
5. Refit the carpet glider if required (fig. 12).
Fig. 11 Fig. 12