Using The Steam Mop - Dirt Devil DD7004 Instruction Manual

USING THE STEAM MOP

This steam mop is designed to clean hard floor surfaces that will
withstand high temperatures and to refresh carpets. Do not use on
unsealed wood or waxed floors. Before using the steam mop on
new surfaces, check the manufacturers care advise for flooring or
test an inconspicuous area before proceeding to clean/refresh the
main area.
1. Vacuum or sweep the floor surface prior to steam cleaning.
2. Pre-treat and heavy or stubborn stained areas on vinyl or
linoleum floors with a mild detergent solution suitable for the
flooring type.
3. The floor head is supplied with one microfiber cleaning pad and
the carpet ring already fitter. If using on a hard floor remove the
carpet glider (see fig. 10).
Fig. 6
4. Check if the steam adjustment knob is in the 'Off' position (fig. 6).
5. Pull out the water reservoir stopper (fig. 7).
6. Keeping the body of the steam cleaner tilted, use the water jug
to fill the reservoir with water (fig. 8). If you live in a hard water
area it is recommended to use distilled or softened water. Do not
exceed the MAX lined marked on the front of the reservoir.
Never add any cleaning or perfuming liquids to the water
reservoir. Refit the stopper.
7. Fully unwind the cable plug in and switch of at the mains.
8. Turn the steam adjustment knob, select one of the steam
settings and the indicator will initially illuminate red to show that
the power is connected and the mop is heating up. When the
steam mop is ready to use the indicator will change to green.
Fig. 7
Fig. 8