Table of Contents
Advertisement
Anti-tilt protection
Warning! Install the anti-tilt protection to
prevent the appliance to fall with incorrect
loads.
Important! Make sure you install the anti-tilt
protection at the correct height.
How to install the anti-tilt protection
1. Set the correct height and area for the ap-
pliance before you attach the anti-tilt pro-
tection.
2. Make sure that the surface behind the ap-
pliance is smooth.
3. Install the anti-tilt protection 317 - 322
mm down from the top surface of the ap-
pliance and 80 - 85 mm from the side of
the appliance into the circular hole on a
bracket. Screw it into the solid material or
use applicable reinforcement (wall). You
can find the hole on the left side at the
18
back of the appliance. See the illustration
bellow.
4. If you changed the dimensions of the
cooker, you must align the non-tip device
correctly.
Important! If the space between the bench
cupboards is larger than the width of the
appliance, you must adjust the side
measurement to center the appliance.
Electrical installation
The manufacturer is not responsible if you
do not follow safety precautions from the
chapter "Safety information".
This appliance is supplied without a main plug
and a main cable.
Applicable cable type: H05 RR-F with ade-
quate cross-section.
Warning! Before you connect the mains
cable to the terminal, measure the voltage
between phases in the house network.
Then, refer to the connection label at the back
of the appliance to use the correct electrical
installation
This order of steps prevents from installation
errors and damage to the electrical
components of the appliance.
The power cable must not touch the part
of the appliance shown in the illustration.
80-85
mm
317-
322 mm
www.zanussi.com
Advertisement
Table of Contents
