Advertisement
FOOTRESTS
Footrests are supplied separately to the main commode. Please examine your footrests for
any visible damage before use. If you see any damage or suspect a fault, please contact your
supplier immediately.
In this case, please do not use your product as it may compromise your safety.
1.
Remove the commode footrests from their packaging
2.
You will see on each of the front legs of the commode main frame about 150 mm
high from the castor 2 retaining lugs either side
3.
Take the footrests and align the holes in the inverted 'U' section with the lugs and
lower down into place.
4.
Rotate the footrests towards the commode so that they clip into place.
USE OF THE COMMODE
When moving always lift the commode by placing you hands on the tubular metal frame
beneath the blow moulded seat.
Do not allow children or unauthorised persons to play with or use the commode.
•
Do not rock back and forth or sideways when using the commode as this will cause
•
excessive stress and possible damage and failure which may cause injury.
Do not use the commode outside the home or on uneven surfaces (such as in the
•
garden) as this will cause stress to the legs and possible damage which may cause
injury. It is not intended as a wheelchair.
Do not place fingers or foreign objects into any of the exposed tubular sections as
•
this can lead to serious injury.
When operating the brake mechanism, do not stamp on the lever as this may cause
•
damage to the mechanism and possible failure.
Not for use in the shower. Dry immediately if the Linton becomes wet.
•
CLEANING
A useful guide to decontamination is MHRA leaflet DB2003(06).
Do not use abrasive cleaners as this could damage the surface of the equipment. For
cleaning, wipe with a clean cloth soaked in detergent solution and wring out. Depending on
the detergent manufacturer's instructions the solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed periodically and the
detergent changed frequently. The detergent should be rinsed or wiped off using a clean
cloth immersed in clean water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe over with a
clean cloth and a compatible liquid disinfectant. After disinfecting clean with clean water
and dry.
When using detergent or disinfectants then please refer to manufacturers' instructions and if
unsure then consult your local Infection Control Specialist for advice.
This equipment can be cleaned/disinfected by moist heat at 80
or autoclaved at 80
joints with a water dispersing agent, e.g. WD40.
Fixing and Maintenance Instructions
o
C for at least 1 minute. After cleaning or disinfecting dry and treat all
o
C for a minimum of 1 minute
3
Advertisement
